Size & Fit Charts
Sizing Instructions
We would like to ensure that the apparel you purchase really fits you – in order for them to perform their purpose properly. Please invest a moment of your valuable time to check out the measurements guide and corresponding size table to avoid errors.
To take the right measurement, please find the clothes that fit you well and measure it.
SHIRT MEASUREMENTS
Product Chest Circumference
This is the actual product circumference at the chest level.
Chest Circumference
With a cloth tape, measure around your chest, start just under your arm. Please check the product size chart below to select your appropriate size.
1/2 Chest
Place the selected garment on a flat surface, face up. Try to flatten it as much as possible by ironing the upper part with your hand. Measure from right to left edge just below where the sleeve attaches to the body of the shirt.
Neck
Unbutton the shirt and lay it on a flat surface. Measure from center of button across the colar to the outside of the buttonhole.
Sleeve Length
Wearing a shirt that you like, measure with an arm at your side, from the shoulder seam all along the arm until you find the desired length. We recommend that the sleeve should go to the base of your thumb (located at the wrist joint).
1/2 Waist
Button up the shirt and lay it on a flat surface. Measure from left edge to right edge at the waistline.
Body Length (back)
Button up the clothes and lay it on a flat surface, back facing up. Measure from the center, just below collar, to the bottom of the shirt.
Body Length (front)
Button up the clothes and lay it on a flat surface, front facing up. Measure from the top center of the shirt to the bottom of the shirt.
For the jackets with raglan sleeves, like Stratus® or Cumulus®, the sleeve measurements should be taken from the base of the collar down to the sleeve cuff.
PANTS AND SHORTS MEASUREMENTS
Waist Circumference
With a cloth tape, measure around your waist, just above the hip bone.
1/2 Waist
Put clothes that fit you well on a flat surface, face up, and then iron them with your hand. Measure from left to right edge at waist height.
Inseam (L30,L32,L34,L36)
Button up the pants. Lay the pants out on a flat surface. Measure the inseam distance from crotch, where the front and back seams meet, to the bottom of the leg.
Overall Length
Button up the pants. Lay the pants out on a flat surface with outseams at both edges. Take care to pull any wrinkles and fullness from the back panel. Measure the distance from the top of the waistband to the bottom of the hem.